Zektor Clarity Prowler™ - Manual (Page 18)

18 Prowler 8x8 User Guide, Version 1.4, 7/15/11
Front Panel Commands
Using Presets - Selecting a Preset, and Toggling “Client Mode”
Once presets have been setup, using the preset is a simple manner of prefixing any button with the
MEM button. To select a new preset:
1 Press the MEM button . The VID / AUD LEDs will start blinking, indicating the Prowler
8x8 is waiting for a preset.
2 Now pressing any button on the front panel, except power, will recall the configuration memo-
rize by that preset. Pressing the power button
will cancel the preset mode and nothing will
be changed.
3 The front panel buttons are mapped to the presets as follows:
• Input buttons 1-8 are mapped as presets 01-08.
• Zone buttons 1-8 are mapped as presets 11-18.
• The ENT button is preset 09.
• The VID/AUD button is preset 10.
• The MEM button is preset 19.
• The CLR button is preset 20.
Another way of using the front panel buttons as presets is to enter the Client Mode. The Client Mode
locks the front panel into a mode where every button is a preset. No other functionality is available
(except power off, and the ability to leave Client Mode). To toggle the Client Mode:
1 Press and hold the ENT button . While continuing to hold the ENT button, press the MEM
button . The ENT LED will light, this indicates you are in the Client Mode.
2 Repeating step 1 will toggle you out of the Client Mode and return you to normal functionality.
AUDIO VIDEO MATRIX SWITCH
AUD
VID
MEM 1 2 3 4
CLR 5 6 7 8 ENT 1 2 3 4 5 6 7 8
B A F E
G
C D
G
A
C
F
D
E
G
B
D
G