Xtramus XG2 V1.3 - Manual (Page 15)

15
Transceiver (Connector):
SFP+ Transceiver is the hardware that is pluggable into the body of XG2. Unlike RJ-45 connector that there is no
component inside at all, SFP+ Transceiver is an active component that consumes power from XG2 and it has the
key function that convert signals between optical data flow and electronic data flow.
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES ®
A
B C D
E
A : Handgrip to remove module from XG2 easily
B : Connection from LC fiber connector that is described above
C : Bottom of the transceiver module
D : Electronic conductor to XG2 body
E : Size of matchstick.
For different transmission purpose, the component inside SFP+ form factor can be 10BASE-LR or 10BAST-SR
mode.
When SFP+ transceiver is plugged into the XG2, the LED of SFP+ is Amber. If the inserted SFP+ transceiver is
attached by a fiber with LC connector with going on signaling, the LED becomes Green. The LED of LR is either
Green for 10BASE-LR mode or Amber for 10BASE-SR mode. Details are shown at the table below:
LED Status
Type Label LED Description
Amber Remind user that the SFP+ form factor
transceiver (connector) is connected.
Green Transceiver (connector) with powered
optical fiber is connected.
Fiber Connector
(Transceiver)
Status
SFP+
OFF No SFP+ transceiver (connector) is
plugged.
Green Connector of LR Transceiver is plugged. 10BASE-R
Mode
LR
Amber Connector of SR Transceiver is plugged.
SFP+ LED LR LED Description
No SFP+ form factor transceiver (connector) is plugged.
(Amber) (Green)
LR mode SFP+ form factor transceiver (connector) is plugged. No
powered fiber is connected
(Amber) (Amber)
SR mode SFP+ form factor transceiver (connector) is plugged. No
powered fiber is connected
(Green) (Green)
LR mode SFP+ form factor transceiver (connector) is plugged.
Powerd fiber is connected
(Green) (Amber)
SR mode SFP+ form factor transceiver (connector) is plugged.
Powerd fiber is connected