wePresent WiPG-1500 - Manual (Page 51)

51 Chapter 11 Web Management
→Back
t You can select “obtain IP address automatically” or “Use the following IP
address”
t IP Address: The default value is 192.168.100.10.
t Subnet Mask: The default value is 255.255.255.0
t Default Gateway: The default value is 192.168.100.10
t DNS Server: The default value is 192.168.100.10
t You can select “auto(Enable/Disable DHCP Server” or “Disable”)
t Start IP: The start IP address of DHCP Server.
t End IP: The end IP address of DHCP Server
t Subnet Mask: The default value is 255.255.255.0
t Default Gateway: The default value is 192.168.100.10
t DNS Server: The default value is 192.168.100.10
< Wireless Setup>
t Wireless LAN: The default value is “Enable”
t SSID: SSID string, max. Length is 32 bytes.
t SSID Broadcast: The default value is “Enable”
t Channel: to set fixed channel or Auto. The “Auto” means after power on
wePresent WiPG-1500, it will scan all of wireless channel and select clear one
channel automatically.
t Encryption: you can select “Disable” or one of WEP/WPA/WPA2 64bit or 128bit
in ASCII or HEX string.
t Key: If Encryption is enabled, you have to set key value according to the
encryption mode you selected.
t Channel Bandwidth: select from 20M or Auto (40M/20M)
< AP Client>
t Connect to Existing AP: Input the SSID of Home WiFi AP you want to connect.
t Encryption: you can select “Disable” or one of WEP/WPA/WPA2 64bit or 128bit
in ASCII or HEX string.
t Key: If Encryption is enabled, you have to set key value according to the
encryption mode you selected.
t Press Apply button, and follow the reboot instruction to make it work.
< Host Name and Domain Name>
t Host Name: It will use the same name as SSID for the device host name
t Domain Name: You can also enter the domain name of this device if there is
DNS server available.