TVLogic VFM-056W - Manual (Page 15)

Vie
wfinder M
onit
or 15
• TimeCode
- Used to set the time code among OFF, VITC and LTC.
• Image Mirror (Hor.)
- Used to reverse the left and right of the image.
- The OSD menu is also reversed.
• Screen TALLY On/Off
- Used to set Tally operation according to
the input level of TALLY IN terminal which is
among the terminals of XLR 4P connector in
the rear.
• Screen TALLY Operating Level
- Used to set the input level of Tally operation.
(Open&Low : less than 0.6V, High Range :
2.5V to 12V.)
- High: Set the level as “High” to activate the
Tally and set the level as “Low” to inactivate
the Tally.
- Low: Set the level as “Low” to activate the Tally
and set the level as “High” to inactivate the Tally.
• Screen TALLY Color
- Used to set Tally color.
- Available colors are Red, Green and Yellow.
[4] Display/Video [5] Waveform / Level Check
(VFM-056WP-N Only)
6. Menu Operations
• Waveform/Vector
- Used to select among [Off], [Waveform Y],
[Waveform Cb], [WaveForm Cr], [Vectorscope].
- Waveform or Vectorscope is displayed on the
bottom right of the screen.
- Vectorscope : Displays the color components
B’-Y’ and R’-Y’ of the input signals on the X-Y axis.
- Is classified into two kinds depending on
the input signal – SD or HD. 100% and 75% are
indicated on the screen.
- Waveform YCbCr: Displays each waveform
for luma(Y’) and Cb/Cr components of the
input signal.
• Waveform Intensity
- Used to set the brightness level of the
Waveform/ Vectorscope display from 1 to 63.
- The higher the number the brighter the
waveform will be.
• Waveform Trans.
- Used to select the transparency option of the
Waveform/ Vectorscope between Opaque
and Blend.
- Even if the option is set to [Opaque], it will
automatically turn to [Blend] when the main
OSD overlaps the waveform/vectorscope.
And turns back to [Opaque] when the main OSD
disappears.