Toyotomi EPH-121 - Manual (Page 8)

NOTE
Room tempe
room tempe
NOTE
Set tempera
1 Insert the plug in electr
2 Press the Operation sw
Power lamp, Panel ope
lit.
3 Press the Temperature
temperature setting.
The heater will be tu
temperature reaches se
The heater will be tu
temperature exceeds t
the room temperature
0.5˚C, the heater will b
desired temperature.
When the heater is turn
Panel select switch can
4 Press the Panel select s
Panel operation lamp w
repeatedly.
[R]: Right panel is opera
[L]: Left panel is operat
[LR]: Both left and right
5 Press the Operation sw
Power lamp, Panel ope
off.
6 Be sure that Power lam
the heater.
[high] ⇒ [mid. H] ⇒
OPERATION
7
INFORMATION
This product is built to be run with the range from closed position (0 degree) to opened position (155
degrees). Hold both ends of the panels securely as described above, and open or close slowly.
Closed condition Opened condition
Closed condition Opened condition
Parallel
155˚ More than 155˚
Parallel
Do not open the panel forcibly to avoid the damage of the heater or
breaking of wire.
WARNING
Lift the front sides of the product a little (approx. 5cm), and open the
panel with the hinge segment centered, so you can open the panels
smoothly.
Do not open and close the panels during operation
and be careful not to touch the heated part such as
surface of the panel and heated air outlet.
CAUTION
OPEN AND CLOSE THE PANELS
EPH-121-T.qxd 11.11.18 10:56 AM ページ 7