Toyotomi EPH-121 - Manual (Page 13)

Check the other appliances are on.
Insert the power plug to the wall outlet
securely.
Current-carrying may be stopped when the
temperature of the temperature detecting
portion reaches to the preset temperature.
Adjust the set temperature to the middle or
high heat level.
In the early stage of use, volatile organic
compound and carbonyl compound will be
produced and it will smell. In that case let
fresh air in sufficiently. The odor will be lesser
by continuing to use of this heater.
Clicking sound: it is the sound of the heater current-
carrying switch and it is not defect.
Ticking sound: It is the sound of the heater
expansion and contraction by
heating and it is not defect.
Buzzing sound: It is the sound of the heater slight
vibration by heating and it is not
defect.
Insert the power plug to the wall outlet securely.
And if the plug is still loose, contact an
electrician and replace the outlet with new one.
Is the power out?
The power plug is inserted to
the wall outlet securely?
The set temperature is adjusted
to the low or gentle heat level?
—
—
The power plug is inserted to the
wall outlet securely? Or the plug
inserted to the outlet is not loose?
Does not work
Does not heat
Odor
Makes noises
Power plug is hot
12
Check point / causes Measures and the method Problem
Check point / causes Measures and method Problem
DEFECT ALARM
TROUBLESHOOTING
When the defect in the production is detected, the safety device will work.
Check if the body is covered with something
and the inlet is blocked. Remove the causes of
overheat and let the product cooled first then
start it again.
Does not work because the tilting switch works.
Use it on a flat and stable surface.
Press the start switch to cancel the starting
time or timer setting. Restart the product and
set the timer again.
Contact the shop where you bought this
product.
Inside the product may be
anomalous overheated.
Does the body incline?
Did you incline the body during
current-carrying or timer
setting?
Temperature sensor may be
broken.
Temperature sensor of the
product surface may be broken.
Operation light is
flashing
Panel current-
carrying lights,
both L & R, are
flashing.
All temperature
lights are flashing.
EPH-121-T.qxd 11.11.18 10:56 AM ページ 12