Thor 4 Ch HD-SDI Encoder w/ CC & AC/3 - Manual (Page 18)

H-2/4HD-EM(S/H)
Chapter 4 WEB NMS Operation
Using the LCD digital display and front buttons for setting configuration is always
an option if you are close by, conveniently you can alter the same settings through a
computer by connecting the device to the web NMS Port. Always make sure that
the computer’s IP address is different from the Units IP address; otherwise, it will
cause an IP conflict. Below is an explanation of how you can adjust settings
through a web portal
4.1 login
The default IP address of this device is 192.168.0.136. (We can modify the IP through
the front panel.)
Connect the PC (Personal Computer) and the device with an ethernet cable, and use
ping command to confirm they are on the same network segment.
NOTE* if the PC IP address is 192.168.99.252, we then change the device IP to
192.168.99.xxx (xxx can be 1 to 254 except 252 to avoid IP conflict).
Use web browser to connect the device with a PC by inputting the encoders IP address
in the browser’s address bar and press Enter.
It will display the Login interface as Figure-1. Input the Username and Password
(Both the default Username and Password are “admin”.) and then click “LOGIN” to
start the device setting.
Figure-1