Signamax 10/100/1000 to 1000Base SFP PoE+ PSE DIN-Rail Mount Hardened Media Converter - Manual (Page 3)

065-1800GSFPZ Hardened 10/100/1000BaseT/TX to 1000Base SFP Media
Converter with PoE/PoE+
V3 3
DIN Rail Installation
The 065-1800GSFPZ can be installed on a DIN rail. Installation steps are as follows:
Wall Mount Installation
The 065-1800GSFPZ can also be installed on a wall or a flat surface. Installation steps are as
follows:
Setup
a) Connect the Ethernet port of the media converter to a PoE Powered Device (PD), such as an IP
camera, or a network device with a network cable.
b) Insert the appropriate SFP into the SFP port. Connect the fiber cable from the device (media
converter or switch) on the other end to the LC connector of the SFP.
c) After the device is powered on, the PWR indicator will all be on. If the indicators are not on, check the
power supply connection.
d) After all cables are correctly connected, the indicators will be lit as per port status LEDs (page 4).
1. Tighten the screws to fix the
DIN Rail plate
1. Tighten the screws to fix the
wall mount bracket 2. Mount the switch on the wall
or on a flat surface with 2 screws
piercing through the mounting
holes to secure it in position.
Upper part
2. Lock the upper part of the DIN
rail clip on the upper side of the
track. Gently press it until the clip
is securely locked on the track.
Press