Dual XML8100 - Manual (Page 12)

12
XML8100 OPERATION
Dock for iPod Operation
Some iPod devices have a thinner design, and
may require changing the rear rubber support at
the back of the dock for the best fit.
To change the rear rubber support, pull upward
on support to remove it. Then replace the support
with the thicker rubber support that is included
in the box.
For the 1st generation, 2nd generation and 4th
generation iPod Nano devices, the left side dock
support can be replaced with a larger rubber
support, for the best fit.
To change the left side rubber support, pull
outward on the rubber support to remove it. Then
replace the support with the larger rubber support
that is included in the box.
To dock an iPod device, first spread apart the side
supports of the dock. Then line up the dock connector
and insert the iPod device into the dock. Release the
side supports to secure the device.