Proceed DAP (non-CE) - Manual (Page 6)

6
Unpacking and Placement
Unpacking Unpack your Proceed ® DAP digital audio processor and keep all packing mate-
rials for future transport . Locate and remove the AC power cord from the
cardboard slot it occupies within the shiping carton.
Placement Place the DAP near the source equipment, thus keeping interconnecting cables
(both digital and analog) reasonably short. It may be placed on a shelf or in a
cabinet where it’s convenient to operate.
Note that adequate clearance for the AC cord and connecting
cables must be left behind the DAP. We suggest leaving at least three
inches of free space behind the DAP to allow all cables sufficient
room to bend without crimping or undue strain.
Ventilation Be sure to allow 2 to 3 inches of clearance above the DAP to allow heat dissipa-
tion through air circulation.
Mechanical drawings are included in this manual to facilitate special installations
and custom cabinet work (see “Dimensions” at the end of this manual).
PRECAUTION For your protection, review “Important Safety Instructions”
before you install your DAP.