Proceed DAP (non-CE) User Manual
Page 20
20
The DAP will display a “L 00” code when it has entered its teaching mode
and is ready to help the remote control learn the commands that corre-
spond to the DAP’s front panel buttons. If no further buttons are pressed
within approximately ten seconds, the DAP will “time out” and return to
normal operation.
2
PRESS AND HOLD THE MUTE BUTTON UNTIL “L 01” APPEARS IN THE
DISPLAY
By holding this button for several seconds, you are instructing the DAP to
give you access to programming options beyond those represented by the
front panel buttons.
The following table lists the special commands that are available for the
DAP. In the second column are the programming “codes” used in the
main
display
to represent those special commands.
special commands table
hard assignment for
operate
L 01
hard assignment for
standby
L 02
display off
L 03
display on
L 04
volume mode
L 05
input select mode
L 06
–10 step in volume control
L 07
+10 step in volume control
L 08
toggle display on/off
L 09
select input 1
L 10
select input 2
L 11
select input 3
L 12
select input 4
L 13
select input 5
L 14
3
USE THE UP/DOWN BUTTONS TO SELECT THE CODE THAT CORRESPONDS
TO THE SPECIAL FUNCTION YOU WOULD LIKE TO TEACH YOUR REMOTE
CONTROL
Pressing the
“up”
button will increase the program code number by one;
“down”
will decrease the program code number by one. Select the desired
code number from the list above.
4
MOMENTARILY PRESS THE MODE BUTTON TO TRANSMIT THAT CODE
Line up the IR window of your remote control with the left side of the
main display
of the DAP, at a distance of approximately 6"-12". Select the to-
be-learned button on the remote, then fire the selected code from the DAP
by pressing
mode
.
Notice that the
mute LED
lights up briefly after you press
mode
. This LED
indicates that the DAP is transmitting the command which corresponds to
the code you have selected. You may repeat the process of selecting special
commands (using
the up/down buttons
) and then transmitting them
(pressing
mode
) until all desired commands have been learned by your
remote control.