Proceed DAP (non-CE) - Manual (Page 12)

12
PR O C E E D R d a p b y M A D R I G A L A U D I O L A B O R AT O R I E S
aes/ebu
analog outputs
~ ac mains
mains fuse:
.5A (250V) slo-blo 5x20mm
please see bottom panel for voltage and other information
spdif bnc eiaj st
digital inputs
PUSH
2 1
3
R
R L
L digital
out remote
IR
2
1 3 4 5 6 7 9 10 8
Rear Panel
Caution! Disconnect all associated equipment from the AC mains
BEFORE making any signal connections and applying power
to the DAP.
1 BALANCED ANALOG OUTPUTS
These outputs provide balanced analog audio (via cables equipped with
XLR-type connectors) to a preamplifier, integrated amplifier, or receiver
equipped with balanced inputs. Balanced interconnection between the DAP
and the component that follows it offers the best quality interconnection
and is highly recommended.
If you engage the variable output mode of operation of the DAP, these out-
puts may be routed directly to a power amplifier that accepts balanced in-
puts. This mode of operation is less desirable sonically than using a high
quality active preamplifier, but may be advantageous under some circum-
stances.
Caution! If you elect to use the variable output mode of the DAP to
allow direct-connection to a power amplifier, be certain to
turn the volume down to a low level before playing any music.
Sending a line-level (maximum volume) signal to your power
amplifier may endanger your loudspeakers.
The pin assignments of these XLR-type male outputs conform to the inter-
national AES standard, and are as follows: