Paxton Superchargers 5.9 Dodge Ram User Manual

Page 16

5-2

P/N: 4809621

18SEP03 v1.0 Dodge Ram 1500(4809621v1.0)

Assemble the bonnet with the injectors.
Using a small amount of engine oil or lithi-
um grease when assembling the injectors to
the bonnet will aid in the installation of the
injectors and prevent damage to the injector
O-rings. Install the bonnet to the throttle
body using the hardware provided.

Install the 3" sleeve to the outlet of the
supercharger with the hose clamps provided.
Do no tighten the hose clamps at this time.

Install the 3" sleeve with the clamps to the
end of the discharge tube that will attach to
the bonnet. Adjust the sleeves and tighten all
clamps. (See Fig. 5-e.)

5.3

BYPASS VALVE ASSEMBLY

Assemble the bypass valve as shown in
Fig. 5-f.

Fig. 5-e

Fig. 5-d

Fig. 5-f

Install the bypass valve with the
vacuum/boost port facing downwards and
tighten the clamps

Install the 5/32" vacuum hose to the port
and route to manifold vacuum.

5.2

AIR DISCHARGE ASSEMBLY

Remove the four factory inlet duct bolts and
factory inlet duct adapter and set aside. It
will not be re-used.

Install the bonnet adapter with the fasteners
provided. Using lock tight on this bolt is
recommended. (See Fig. 5-d.)

AIR INTAKE DUCT

S/C DISCHARGE DUCT