1 supercharger installatio, Supercharger installation and assembly -1, Supercharger bracket assembly – Paxton Superchargers 5.9 Dodge Ram User Manual

Page 11

4-1

P/N: 4809621

18SEP03 v1.0 Dodge Ram 1500(4809621v1.0)

4.1

SUPERCHARGER MOUNTING
BRACKET

Remove the pulley from the stock accessory
belt tensioner and the tensioner from the
stock bracket for re-installation.

This is how the bracket should look prior to
installation. (See Fig. 4-a.) Note the acces-
sory belt tensioner bracket. This spacer will
have to be removed before you install the
bracket. The dipstick goes between the ten-
sioner and spacer.

***NOTE***

The idler pulley and pulley stand-off have been removed.
They will be installed once the supercharger bracket has
been installed.

Fig. 4-a

Mount the bracket in the holes at the stock
accessory belt tensioner location. Remove
the two countersunk allen head bolts and
lower this arm to gain access to the dip-stick
bolt. (See Fig. 4-b.)

***NOTE***

When installing the spacer, you may have to bend the
dipstick. Do not bend it excessively as it will become
harder to get in and out.

Re-install the countersunk bolts.

This is how the spacer should look installed.
Short portion toward the engine block. (See
Fig. 4-c.)

Fig. 4-b

Fig. 4-c

Section 4

SUPERCHARGER BRACKET ASSEMBLY

REMOVE THIS SPACER BEFORE INSTALLING THE S/C BRACKET