OT Systems FTD100Micro - Manual (Page 7)

FTD100Micro Series Installation & Operation Manual
www.ot-systems.com 7
(a) Installation (b) Side view of the clip (c) Side view of the Micro unit pushed into the clip
Fig. 3.3 Micro unit installation on the clip
d) Connect all the signal inputs and outputs at the back of the unit with appropriate cables: fiber
optic cable for optical link, BNC cable for video input/output (Tx/Rx).
e) Once the unit is powered up, check that the red POWER LED on the unit is lit. If not, check
the power supply cable connections between the unit and the power supply socket.
f) With all the signals available at the input and output ports, check the status of LEDs located
on the unit. With correct status of each LED, installation is now completed [for LEDs status, see
Operational Guides
on this manual’s section (5)].
(4) Cable Connections & Setup Procedures
4.1 System cable connections
Signal Type Cable Type Connector
Optical Single-mode or Multi-mode Fibers ST (or FC) Connector
Video Coaxial Video Cable BNC Connector