Installation, Eneral, Icro unit installation – OT Systems FTD100Micro User Manual
Page 6: 3) installation
FTD100Micro Series Installation & Operation Manual
6
(3) Installation
3.1 General
All OT Systems products are thoroughly inspected, tested and securely packaged before
delivery to ensure a stable, intact and trouble-free service. Please check the equipment upon
receipt for any visible damage which may have been caused during shipping.
The FTD100Micro Series (Fig. 3.1) units can be either horizontally or vertically wall-mounted,
or mounted on any fixture, etc. The Micro unit works with an external power supply FT-PA/12V
powered by local 110/220V power.
Fig. 3.1 Micro unit
3.2 Micro unit installation
a)
Mount the clip (Fig. 3.2) onto a fixture, e.g. a plank, (either on the wall or on a flat surface)
with two screws piercing through the holes on the mounting frame to secure it in position.
(a) Front view
(b) Side view
Fig. 3.2
Micro unit’s clip
b)
The provided power supply should also be mounted on the same fixture or in the proximity
for connection of the supply cables to the unit, provided that an AC power supply socket is near
by for powering the adaptor.
c)
Push the Micro unit into the clip to secure it in position. For details, please follow Fig. 3.3.