OT Systems ET8242M-S-DR - Manual (Page 8)

ET8242M-S-DR
Managed Industrial 8-port 10/100/1000Base-T/X SFP Combo + 4-port 1000Base SFP
Ethernet Switch
8

Support 802.3/802.3u/802.3ab/802.3z/802.3x.

RJ45 ports Auto-negotiation: 10/100/1000Mbps, Full/half-duplex; Auto MDI/MDIX.

SFP (Mini-GBIC) combo port supports 100/1000 Dual Mode.

Support 8K MAC addresses. Provides 4 priority queues.

Alarms for power or ports failure by relay output, Carry capacity of 1A @ 24VDC.

Operating voltage and Max. current consumption: 1.84A @ 12VDC, 0.92A @ 24VDC. Power consumption: 22W Max.

Power Supply: Redundant DC Terminal Block power inputs, 12~48VDC on 6-pin terminal block.

Operating temperature ranges from -10°C to +60°C.

Supports Wall Mounting installation; Optional DIN-Rail mounting kit.
Assembly, Startup, and Dismantling
Wall Mounting Kit installation

Assembly: Securely fasten the wall-mount kits to the bottom of module by using the provided screws (6 pcs)
Mount the standalone unit onto a fixture, e.g. a plank, (either on the wall or on a flat surface) with at least 2 screws piercing
through the holes on the mounting frame to secure it in position.

Startup: Connect the supply voltage to start up the Industrial Ethernet Switches via the terminal block.

Dismantling: Locate and remove the securing screws. Usually, but not limited to, at least 2 screws.
DIN rail installation (Optional)

Assembly: Place the Media Converter on the DIN rail from above using the slot. Push the front of the Media Converter
toward the mounting surface until it audibly snaps into place.

Startup: Connect the supply voltage to start up the Industrial Ethernet Switches via the terminal block.

Dismantling: Pull out the lower edge and then remove the Industrial Ethernet Switches from the DIN rail.
Manual Earth Green manual is available in our website. www.ot-systems.com