Default configuration, Entering setup, Legends – NEXCOM NSA 3130 User Manual

Page 57

NSA 3130 User Manual

Default Configuration

Most of the configuration settings are either predefined
according to the Load Optimal Defaults settings which
are stored in the BIOS or are automatically detected and
configured without requiring any actions. There are a
few settings that you may need to change depending on
your system configuration.

Entering Setup

When the system is powered on, the BIOS will enter the
Power-On Self Test (POST) routines. These routines
perform various diagnostic checks; if an error is
encountered, the error will be reported in one of two
different ways:
•

If the error occurs before the display device is
initialized, a series of beeps will be transmitted.

•

If the error occurs after the display device is
initialized, the screen will display the error message.

Powering on the computer and immediately pressing
allows you to enter Setup. Another way to enter
Setup is to power on the computer and wait for the
following message during the POST:

TO ENTER SETUP BEFORE BOOT PRESS

Press the ~~key to enter~~

Setup:

Legends

Key Function

Right and Left arrows

Moves the highlight left or
right to select a menu.

Up and Down arrows

Moves the highlight up or
down between submenus or
fields.

Exits to the BIOS Setup
Utility.

+ (plus key)

Scrolls forward through the
values or options of the
highlighted field.

-(minus key)

Scrolls backward through
the values or options of the
highlighted field.

Tab

Select a field.

Displays General Help.

Saves and exits the Setup
program.

Press to enter the
highlighted submenu.