NEXCOM nROK 5300 - Manual (Page 28)

15
Chapter 2: Jumpers and Connectors
Copyright © 2012 NEXCOM International Co., Ltd. All rights reserved nROK 5X00 Series User Manual
Jumper Settings
(*) for default setting
Voltage Setup Selection (SW3)
Start-up Mode / Pre-Heater Control (SW2)
ON(*) OFF
SW3.1 GPI0 PULL UP 5V Don’t Care
SW3.2 GPI1 PULL UP 5V Don’t Care
SW3.3 GPI2 PULL UP 5V Don’t Care
SW3.4 GPI3 PULL UP 5V Don’t Care
ON OFF
SW2.1 Start up by PW Start up by Ignition(*)
SW2.2 Pre-Heater on Pre-Heater off
ON(*) OFF
SW3.5 GPO0 PULL UP 5V Don’t Care
SW3.6 GPO1 PULL UP 5V Don’t Care
SW3.7 GPO2 PULL UP 5V Don’t Care
SW3.8 GPO3 PULL UP 5V Don’t Care
O N
1 2 3 4 5 6 7 8
O N
1 2
PCI-104 VI/O Voltage Setting (JP4)
CMOS Input Voltage Select (SW1, JP5)
1 5
2 6
1 3 1 3
Pin No. Status Function Description
(1-3)(2-4) (*) Short +3.3V
(3-5)(4-6) Short +5V
Pin No. Status Function Description
1-2(*) Short* VBAT IN
2-3 Short Clear CMOS
Pin No. Status Function Description
1-2(*) Short* VBAT IN
2-3 Short Clear CMOS