NEXCOM IPPD 1600P - Manual (Page 33)

Copyright © 2015 NEXCOM International Co., Ltd. All Rights Reserved. 18
Chapter 3: System Setup
IPPD 1600P/1800P/2100P User Manual
C
haPter
3: s
ystem
s
etuP
Panel Mounting
1. Select a place on the panel where you will mount the Industrial Touch
Monitor.
2. Cut out a shape on the panel that corresponds to the Industrial Touch
Monitor’s rear dimensions.
The thickness of the panel (e.g. steel board, plank, acrylic board, wall,
etc.) where you will mount the Industrial Touch Monitor must not exceed
12mm. If the distance between the front bezel and panel mount hole is
too wide, it will not fit the panel mount kit.
IPPD 1600P IPPD 2100P
IPPD 1800P
401
547
475.4 12mm
305.2
367
12mm
296
12mm