NEXCOM NISE 3600E - Manual (Page 78)

Copyright © 2012 NEXCOM International Co., Ltd. All Rights Reserved. 64 NISE 3600E Series User Manual
Chapter 4: BIOS Setup
SATA Controller(s)
Enables or disables SATA device.
SATA Configuration
This section is used to configure the SATA drives.
Advanced
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Enable or disable SATA Device. SATA Controller(s)
SATA Mode Selection
Serial ATA Port 0
Software Preserve
Serial ATA Port 1
Software Preserve
Serial ATA Port 2
Software Preserve
Serial ATA Port 3
Software Preserve
[Enabled]
[IDE]
Hitachi HEJ421 (80.0G
SUPPORTED
Empty
Unknown
1GB SATA Flash (0.9GB
NOT SUPPORTED
TS8GCFX500 (7.9GB
SUPPORTED
SATA Mode Selection
Configures the SATA as IDE, AHCI or RAID mode.
IDE This option configures the Serial ATA drives as Parallel ATA
physical storage device.
RAID This option allows you to create RAID or Intel Matrix Storage
configuration on Serial ATA devices.
AHCI This option configures the Serial ATA drives to use AHCI
(Advanced Host Controller Interface). AHCI allows the storage
driver to enable the advanced Serial ATA features which will
increase storage performance.
Serial ATA Port 0 to Serial ATA Port 3
Displays information on the SATA devices detected.