NEXCOM NISE 3100eP2 User Manual

Page 66

NISE 3100e, NISE 3100eP2, NISE 3150e User Manual

Chapter 4: BIOS Setup

Video Off Method

This determines the manner in which the monitor is blanked.

V/H SYNC + Blank
This selection will cause the system to turn off the vertical and hori-
zontal synchronization ports and write blanks to the video buffer.
Blank Screen
This option only writes blanks to the video buffer.
DPMS Support
Initializes display power management signaling. Use this option if
your video board supports it.

Video Off In Suspend

This field is used to activate the video off feature when the system enters
the Suspend mode. The options are Yes and No.

Suspend Mode

This is configurable only when the Power Management field is set to
“User Define”. When the system enters the power saving time set in this
field, the CPU and onboard peripherals will be shut off.

HDD Power Down

This is configurable only when the Power Management field is set to
User Define.

When the system enters the power saving time set in

this field, the hard disk drive will be powered down while all other
devices remain active.

Soft-Off by PWR-BTTN

This field allows you to select the method of powering off your system.

Delay 4 Sec.
Regardless of whether the Power Management function is enabled or
disabled, if the power button is pushed and released in less than 4 sec,
the system enters the Suspend mode. The purpose of this function is
to prevent the system from powering off in case you accidentally “hit”
or pushed the power button. Push and release again in less than 4
sec to restore. Pushing the power button for more than 4 seconds will
power off the system.
Instant-Off
Pressing and then releasing the power button at once will immediately
power off your system.