Integrated peripherals – NEXCOM NISE 3100eP2 User Manual

Page 63

NISE 3100e, NISE 3100eP2, NISE 3150e User Manual

Chapter 4: BIOS Setup

Integrated Peripherals

Phoenix - AwardBIOS CMOS Setup Utility

Integrated Peripherals

Item Help

Menu Level



↑↓→←

: Move

Enter: Select

F1: General Help

+/-/PU/PD: Value

F10: Save

ESC: Exit

F5: Previous Values

F7: Optimized Defaults



OnChip IDE Device

USB Controller

USB 2.0 Controller

USB Keyboard Support

Azalia Audio

Onboard LAN Boot ROM

Onboard Serial Port 1

Onboard Serial Port 2

Onboard Serial Port 2 Mode

Onboard Serial Port 3

Onboard Serial Port 4

Onboard Serial Port 5

UART5 Mode Select

Onboard Parallel Port

Parallel Port Mode

x ECP Mode Use DMA

Press Enter

Enabled

Disabled

3F8/IRQ4

2F8/IRQ3

RS232

3E8/IRQ4

2E8/IRQ3

2E0/IRQ4

Normal

378/IRQ7

SPP

USB Keyboard Support

Due to the limited space of the BIOS ROM, the support for legacy USB
keyboard (in DOS mode) is by default set to Disabled. With more BIOS
ROM space available, it will be able to support more advanced features
as well as provide compatibility to a wide variety of peripheral devices.

If a PS/2 keyboard is not available and you need to use a USB keyboard
to install Windows (installation is performed in DOS mode) or run any
program under DOS, set this field to Enabled.

Azalia Audio

This field is used to enable or disable the Azalia audio.

Onboard LAN Boot ROM

Enable this field if you wish to use the boot ROM (instead of a disk drive)
to boot-up the system and access the local area network directly.

If you wish to change the boot ROM’s settings, type the and
keys simultaneously when prompted during boot-up. Take note:
you will be able to access the boot ROM’s program (by typing +
) only when this field is enabled.

Onboard Serial Port 1, Onboard Serial Port 2, Onboard Serial Port
3, Onboard Serial Port 4 and Onboard Serial Port 5

3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, 2E0/IRQ4
Allows you to manually select an I/O address for the serial port.
Disabled
Disables the serial port.

OnChip IDE Device

This field is used to configure the IDE device installed in the system.

USB Controller

This field is used to enable or disable the Universal Host Controller Inter-
face (USB 1.0).

USB 2.0 Controller

This field is used to enable or disable the Enhanced Host Controller Inter-
face (USB 2.0).