Installing a dimm – NEXCOM NISE 3100eP2 User Manual

Page 47

Chapter 3: System Setup

NISE 3100e, NISE 3100eP2, NISE 3150e User Manual

Installing a DIMM

Ejector tab

1. Locate the DIMM socket on the board.

2. Push the ejector tabs which are at the ends of the socket outward. This

indicates that the socket is unlocked.

3. Seat the module vertically, pressing it down firmly until it is completely

seated in the socket. The ejector tabs at the ends of the socket will
automatically snap into the locked position to hold the module in place.

DIMM

Ejector tab