Usb configuration, Ide configuration – NEXCOM EBC 353 User Manual

Page 51

EBC 353 User Manual

Chapter 3: BIOS Setup

Configure SATA As
IDE

This option configures the Serial ATA drives as Parallel ATA physical
storage device.

RAID This option allows you to create RAID or Intel Matrix Storage

configuration on Serial ATA devices.

AHCI This option configures the Serial ATA drives to use AHCI (Advanced

Host Controller Interface). AHCI allows the storage driver to enable the
advanced Serial ATA features which will increase storage performance.

SATA Controller(s)
Enables or disables SATA ports 0-3.

Advanced

→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit

Enables Legacy USB support.
AUTO option disables legacy
Support if no USB devices are
connected. DISABLE option will
keep USB devices available
only for EFI applications.

USB Configuration

USB Devices:

None

Legacy USB Support

EHCI Hand-off

Device reset time-out

[Enabeld]

[Disabled]

[20 sec]

USB Configuration
Displays the detected USB devices.

Legacy USB Support
Enable Enables Legacy USB.
Auto

Disables support for Legacy when no USB devices are connected.

Disable Keeps USB devices available only for EFI applications.

EHCI Hand-Off
This is a workaround for OSs that does not support EHCI hand-off. The EHCI
ownership change should be claimed by the EHCI driver.

USB Configuration

This section is used to configure the USB.

IDE Configuration

This section is used to configure the IDE drives.

Advanced

→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit

SATA Ports (0-3) Device Names
if Present and Enabled.

SATA Port0

SATA Port1

SATA Controller(s)

Configure SATA as

Not Present

[Enabled]

[AHCI]