NeoPro Tahoe-Veo - Manual (Page 8)

8
Connector Labels Signal type(s)
Y, Pb, Pr High definition component video inputs
1 - 80
High definition component video outputs over
Cat5
IR
Input for unmodulated IR control signal via
3.5mm 2 conductor plug (tip = signal)*
RS232 Serial port for control (bidirectional)
USB
USB port for control. Software is provided to setup
USB as a virtual serial port. See the Serial
Protocol and USB Driver Installation section of
this manual
AC 90-240VAC
AC power inputs (50-60Hz) via IEC320 appliance
inlet. Connect last, after all I/O cables
*Some IR repeater systems are designed to work only with their own IR
blasters, and a common ―workaround‖ is to cut these blaster cables and add a
3.5mm plug on the end. In some cases, repeater systems will have noise that
prevents signals from being decoded.
RS-232 Connection Details
The serial port is wired as a DCE device, and should be connected to a
computer‘s RS-232 port with a straight through cable. Connection to most
control systems should be with a straight through type serial cable, such as the
cable provided with the matrix switch. For the command protocols, see the
Serial Protocols section of this guide.
Pin 1 (for reference only)
Pin 2 Transmit (Data out of unit)
Pin 3 Receive (Data in to unit)
Pin 5 Ground