NeoPro Tahoe-Veo - Manual (Page 11)

DOC42-00035-A-Tahoe_Integrators_Guide.doc 11
grounded. A display with a three wire AC plug meets this requirement, but if the
display has a two wire plug, you should ground the Cat5 receiver directly to the
AC Outlet.
We highly recommend reviewing the AC ground at each display outlet and rack
location to ensure proper wiring and compliance with the NEC.
When using external Cat5 surge suppressors to further protect your system, the
ground connection is absolutely required as the surge suppressor only works
when properly connected to ground.
Testing Cables Prior To Use
When using Cat5 cable testers/certifiers, the cable should map each pin straight
across (i.e. 1 to 1, 2 to 2, through 8 to 8).
Operation
Overview
Generally there are three ways to control the matrix switch:
1) Front panel buttons
2) IR remote
3) Serial commands (RS232 or USB)
This section of the user guide deals with the front panel and IR remote methods.
Serial commands are discussed in the section titled ―Serial Protocol‖ further
down in this document.
Front Panel Control
The front panel uses NeoTouch technology, which senses a human finger
touching the panel without any moving parts. The buttons also have LED
indicators which will help you understand what mode the system or menu is in
at any time. The front panel is shown below.