Knox Video RSII - Manual (Page 8)

Audio Channels:
Levels:
Unbalanced audio: 3v p-p unbalanced audio
Balanced audio: up 16dBu
Frequency Response: 20Hz through 30KHz
Control:
RS232/RS422: 2 DB9 female (front and rear--front panel DB9 is
RS232 only)
Ethernet: RJ45(default IP 192.168.168.48 port 3001)
Control Panel: 1 DB25 male (behind removable front cover)
Power Consumption:
Composite Y/C: nominal 15v, 2A from external switching power
supply
Input Voltage: 100-240VAC, 50/60 Hz, .5A, 40 watts maximum
Dimensions: 19” wide by 3.5” high by 10” deep, 2RU
Shipping Weight: 12 pounds
RGB/Y,Pb,Pr: nominal 15v, 2A from external switching power
supply
Input Voltage: 100-240VAC, 50/60 Hz, .5A, 40 watts maximum
Dimensions: 19” wide by 5.25” high by 10” deep, 3RU
Shipping Weight: 12 pounds
SDI: Internal switching power supply
Input Voltage: 90-264VAC, 47/63 Hz, 100 watts maximum, internally
fused
Dimensions: 19” wide by 3.5” high by 10” deep, 2RU
Shipping Weight: 13 pounds
Page 3 Page 16
KNOX VIDEO
RSII Routing Switcher System
KNOX VIDEO
RSII Routing Switcher System
3.4.8 ADDITIONAL SOUND CONTROL COMMANDS
$ci clears all input trims
$cxxi clears input trim for input xx
$c sets all VTB for all outputs to default* values
$cxx sets all VTB for output xx to default* values
$cvxx sets all volumes to value xx, where xx is 00-63 (00=+4dB)
$dxx dumps VTB values for output xx to the console
$di dumps table of all input trim values to the console
Syntax notes:
Any command which allows a + or - also allows a number in front of the + or
- to indicate multiple steps; so $vxx+ increases volume by one step; $vxx3+ increases
it by three steps
Volume, bass and treble allow an absolute number to be entered, but balance
and trim allow only steps to be specified)
*Default values are volume at its lowest point, bass, treble, and balance at
mid-point