KLING & FREITAG K&F SEQUENZA 5 W - Manual (Page 69)

User's manual K&F SEQUENZA 5 incl. accessories
KLING & FREITAG GMBH © 2015 Version 4.1 Page 69 of 88
Tip
During the inspection, you must pay special attention to the following points:
• Mobility of the spring bolts. The bolts must move easily and snap securely into place.
They must protrude at least 0.5 mm out of the joining plate on the opposite side.
• Impact and corrosion damage on the flying frame and on the speaker enclosure.
• Joint connectors and bolts
• Adhesion
• Tight fit of the front bolts
14. Optional BGV C1 Certification
In Germany, you have the possibility to have your system individually certified. If required,
you can request the necessary basis of calculation from KLING & FREITAG. On the speakers as
well as on the flying frame, there is a field where an inspection label can be affixed.
Seal of approval box on the
SEQUENZA 5 W speaker Seal of approval box on the
SEQUENZA 5 B speaker
TO BE INSTALLED BY QUALIFIED
RIGGERS ONLY!
READ MANUAL AND SAFETY
INSTRUCTIONS BEFORE USE!
LOAD LIMIT:
IT'S MANDATORY TO CALCULATE
ANGLE SETTINGS AND LOAD
LIMIT WITH THE ARRAY SOFTWARE
'CON:SEQUENZA+' . ITS SAFETY
DIRECTIONS HAVE TO BE
FOLLOWED STRICTLY!
WT: 23,5 kg
SER.-NO.:
PWR:
IMP:
all pins parallel to out
-
1 - 2 -
1+
2+
+
IN
Seal of approval box on the SEQUENZA 5
flying frame
WT: 16,3 kg
SER.-NO.:
PWR: 350 W
IMP: 16 W
all pins parallel to out
-
1 - 2 -
1+
2+
+
IN
'CON:SEQUENZA+' . ITS
SAFETY DIRECTIONS HAVE TO
BE FOLLOWEDE STRICTLY!
ANGLE BETWEEN FRAME
AND 1st SEQUENZA 5
HOLE IN
CABINET
1st SEQUENZA 5