KBC Networks FDVA4-M1T-R-WSC - Manual (Page 3)

Manual-FDVA4-Rev1009.pdf
Page 3 of 11 www.kbcnetworks.com
Copyright © KBC Networks Ltd.
1. Overview
1.1 Introduction
The FDVA4-M1T-WSC/FDVA4-M1R-WSC series is designed using advanced ASIC and
high-speed DSP technologies. This series employs multiplexing and de-multiplexing
techniques to transmit and receive 4 channels of Video over a multi-mode optical fiber in all
digital signaling with no compression; making it ideal for applications where input signal
integrity and quality must be maintained and no loss should be induced. Because this
series utilizes all-digital, non-compression technology, it is able to transmit signals without
distortion; whereas the analog technology inherently noisy, low quality, long term instability
and susceptible to electromagnetically and environmental interference. This series accepts
a variety of video inputs, such as analog or digital video recorder, DVD/VCD, digital camera,
and CCTV. PAL, NTSC and SECAM standards are supported. Plug-and-Play design
ensures ease of installation and no electrical or optical adjustment is required. LED
indicators are provided for showing operating status.
The FDVA4-M1T-WSC/FDVA4-M1R-WSC series is fully assembled using SMT
components for stability and reliability.
1.2 Technical Specification
VIDEO
Number of Channels
4
Signal Level 1.0V
PP
typical, 1.5V
PP
max.,75Ω
Differential Gain < 2%
Differential Phase < 2º
Signal to Noise Ratio (SNR) 62dB typical
Connector Type BNC
OPTICAL
Number of Fibers
1
Wavelength 1310nm
Optical Out Power
≥ -7 dB
Optical Sensitivity ≤ -20 dB
Fiber power budget ≤ 13 dB
Fiber Type 62.5/125μm(MM)
Connector Type ST/PC
Distance 0 ~ 2km