Junger Audio b46 - Digital Audio Leveler User Manual
Page 24

5. OPERATION
5.1
ADJUSTMENT OF
PARAMETERS
in all menus
5.2
GAIN /LOUDNESS
DISPLAY
After selection of one of the utility or function menus by
pushing any of the EDIT- buttons or the SELECT button one
can adjust displayed parameters.
CONTROL switches between parameter selection and
parameter adjustment mode, selected
push
parameter or value is highlighted by arrows
on display
CONTROL change of parameter selection or
adjustment of selected parameter value
(see menu explanation)
turn
Each time SELECT button is pushed it opens next utility menu.
If a function menu is opened (after pushing related EDIT
button) the SELECT button changes the channel selection.
After finishing of settings ESC button switches back to main
level display. All settings are stored as current adjustment
automatically.
The Loudness display becomes available if the loudness mode
is switched ON (see 5.5, 5
th
menu item). The loudness display
is showing short term loudness for the two channel pairs in
numerique value in LKFS units. In case there is no loudness
mode selected only the Gain display becomes available after
pushing the SELECT button.
Gain display shows gain setting for all channels. You can jump
to the gain menu from any other edit menu by pushing ESC
button. The character on the left hand side of the display
shows the selected loudness measurement method. “I” stays
for ITU.1770 mode.
Adjustments are made by turning&pushing CONTROL knob as
described previously (see 5.1).
I12 -24.0 I34 -27.0
O12 -23.0 O34 -29.0
Ixx:
shortterm Loudness in LKFS of the input channel pair
Oxx:
shortterm Loudness in LKFS of the output channel pair
GAIN 1: 0.0
3: 0.0
I >M:< 2: 0.0
4: 0.0
M:
master control, ganging level settings for all channels
following channel 1
GAIN 1…4:
channel independent -15.0 ... +15.0 dB
I:
If the “I” shows up left hand of “M:” ITU weighting is
turned on (see 5.5 – leveller menu)
page 5-2 operation manual b46, chapter 5 -Operation-