Brc 8 – Junger Audio BRC C8000 - Remote Controller User Manual
Page 7

BRC 8
4
Principal of operation – setting up one example operating button
We assume to setup operating button #2 to issue a GPI #10 when pushed. It shall load a preset in a module.
If the preset is loaded that module issues GPO #10. On reception of GPO # 10 the button must light green.
Hold the and press
Push operating button #2
Push the
Turn the
> PUSH 1GPI
<
Push the
Turn the
> GPI STATIC <
Push the
Turn the
> 10
<
Push the
Turn the
> TALLY GREEN <
Push the
Turn the
< 10
<
Push the
Principal of operation – controlling gain of an example module
If the BRC 8 is setup for controlling gains (GAIN CONTROL = LINKED GAIN or GROUPED GAIN)
The display after power uo sequence shows the fist module that one may remote control gain settings :
8086 Loudness Proc 0
module type / module name
2L/2R Gain: x.y dB
channel / "Gain:" / value
You must press the
Now turn the
If you press the
channel(s) which will be controlled. The display depends on the setup of the processor and the type of
module. E.g. if the 8086+ is set for 4x2 operation :
And the audio channels for Program 1, 2, 3 are not linked, you will be able to individual control
Ch 1, 2, 3, 4, 5, 6 but Ch 7/8 together because they are linked.
Similar applies if the 8086+ is set up fro 5.1 + 2.
Initialize to factory defaults
After a firmware update or if the BRC 8 does not work properly you can perform a general reset of the panel.
Hold down operating button #1 and turn power on. Wait until the display shows "C8000 controller".
Pls. keep in mind that this will erase all button settings.