Junger Audio BRC C8000 - Remote Controller - Manual (Page 4)

BRC 8
1
Introduction
The BRC 8 Remote Controller is designed to offer a simple remote control hardware interface for a
dedicated C8k.
Mainly to control GPI related functions by a push button (like loading presets) and display a tally style
feedback for the operator.
For a selected number of c8k modules it also allows to directly control the GAIN setting of audio channels or
programs.
The physical interface and the communication protocol is CAN (Controller Area Network) that is also used
inside a c8k frame for module intercommunication.
The BRC 8 Remote Controller functions are limited to operating needs rather than setting up a device that
should be done via the browser based GUI.
Hardware concept (rear view)
The BRC 8 Remote Controller is powered by an external 5V power supply that comes with the panel.
A 9 pin D-Sub and two RJ45 connectors are looped through to connect to the C8702 frame controller and
other panels (up to eight) on the same CAN bus.
CAN bus termination switch (must turned on only at the far most panel on the bus).
Up to 300m distance from the far most BRC 8 Remote Controller to the C8702.
Hardware concept (front view)
8 illuminated push buttons
these operating buttons may be setup for different color schemes (tallies),
GPIs and button behavior
2x 20charcter LCD display
info and setup display
Rotary encoder with push
multi turn rotary encoder, integrated push button
function
2 micro switches
to control the setup and operating function
Power switch
rocker switch