Junger Audio C8685 - Audio Delay - Manual (Page 4)

digital audio
modular
processing system
C8000
8, 4, 2 Channel Audio Delay
C8685
4/11
switch settings
BUS-EN: ON
Connects the outputs to the C8k audio buses on power up
OFF
Disconnects the module outputs from the C8k buses on power up
SW1 #2 not used
SW1 #3 not used
ID +16: ON
CAN address is extended by +16 (counting from 0x10 to 0x1F)
OFF
CAN address is standard (counting from 0x0 to 0xF)
Important note! To avoid audio bus conflicts when you replace a C8685 or install an additional one and
the configuration is unknown, the output bus drivers must be disabled before inserting it. If all settings are
done remotely and the unit fits into the bus assignment scheme of a frame, you must remove it and place
the switch back into position BUS-EN=ON.
rotary encoder settings
ADDRESS: This rotary encoder sets the CAN ID of the C8685. The 16 switch positions
are hexadecimal numbers (0x0 to 0xF).
remote control operation
- Web-server based remote control of parameters via frame controller C8702
- 3
rd
party remote control by http protocol based API
(please contact Junger Audio for details)
- Hardware GPI/O control of preset operation and special module functions
- Remote control by the brc8x Broadcast Remote Controller via CAN bus