Junger Audio C8685 - Audio Delay - Manual (Page 10)

digital audio
modular
processing system
C8000
8, 4, 2 Channel Audio Delay
C8685
10/11
The bus status may be presented to external monitoring systems
via SNMP. The frame controller summarizes such status
information and generates SNMP traps for the frame as an
entity or may activate GPOs (if GPI/O module(s) are installed).
The SNMP manager may afterwards poll the “modulesStatus”
for more detailed status information per input (see SNMP
documentation for details).
Input Bus selection here you assign the audio signals from the c8k busses to the
delay inputs. You may select one bus that carries all 8 channels
by the so called 8ch Mux mode (8 channels multiplexed on one
bus line) or you may select the audio signals for a specific pair of
delay inputs from a two channel bus or you can mix this selection
by extracting channel pairs from the 8ch Mux bus and from two
channel bus.
Output bus assignment you may assign all 8 channels of the delay output to one bus that
carries them by the so called 8ch Mux mode and / or you may
assign pairs of delay outputs in 2ch mode to dedicated busses.
Enable C8000 Bus Drivers activates (from tri state mode) all module bus drivers.
Transparent CS-Bits defines if the AES channel status bit will be put through from the
input or if it will be exchanged by the following settings:
Format : Professional
Audio Mode : Audio
Emphasis : None
Freq. Mode : Locked
Sample Freq. : 48kHz
Channel Mode : Not Indicated
User Bits : None
Auxiliary Bits : 24Bit
Audio Word Length : Not indicated