ILUMINARC Ilumiline™ Inground Tri-12 IP - Manual (Page 18)

Operation
14 Ilumiline Inground IP Optic 25 Series User Manual Rev. 10
When you scroll
through the
menu options,
you will see
many of them that do not
correspond with the menu
map. Skip them, as they
do not work with the RGB
only output products.
RGB Functions Menu Map
(Ilumiline Inground Tri 12 IP Optic 25 RGB)
Main Level Programming Levels Description
DMX 001~512 N/A Sets the DMX starting address
PERSON
ARC1
N/A
3-channel: RGB control
ARC1+D 4-channel: RGB control + dimmer
ARC FULL
7-channel: RGB control, dimmer, color macro,
strobe, dimmer speed
REMOTE Allows using the ILUMICON unit
SOLID 1-channel: dimmer
SPECIAL 1 6-channel: RGB per module
CALIB
WHITE (1~11)
RED
GREN
BLUE
0~255
Determines the white balance for the color macros
RGBTOW
Determines the white balance when RGBTOW is
active
DIMMER
OFF
N/A
Dimmer works in linear mode
DIM 1
Dimmer works in non-linear mode, from fast to
slow. DIM 2
DIM 3
DIM 4
STATIC
RED
0~255 Configures the static color and effect
GREN
BLUE
STRB
SETTINGS
COLOR
OFF Maximum output, unbalanced white
RGBTOW
White output is as per CALIB > RGBTOW
settings
UC Output matches that of product’s previous versions
RESET NO/YES Resets unit to factory default settings
Programming
All programming functions apply to both Ilumiline Inground IP products, unless otherwise
noted. Perform all programming from the control panel. Refer to the Menu Map section to
understand the menu options.
Use and
DMX Personality
1. Go to PERSON and select any DMX personality.
2. Make sure to rearrange the DMX addresses of all products in the current DMX
universe to avoid address overlapping.
DMX Starting Address
1. Go to DMX.
2. Select a starting DMX address (001~512).