ILUMINARC Ilumipod™ 18g2 IP - Manual (Page 6)

Introduction
2 Ilumipod 18g2 IP Optic WW User Manual Rev. 3
There are no
user-serviceable
parts inside this
product. Any reference to
servicing you may find in
this User Manual will only
apply to properly certified
ILUMINARC® technicians.
Do not open the housing
or attempt any repairs
unless you are certified to
do so.
Please refer to all
applicable local codes and
regulations for the proper
installation of this product.
Keep this manual
for future
consultation. If
you sell this product to
another user, make sure
that they also receive this
manual.
In the unlikely
event that your
Ilumipod 18g2 IP
Optic WW may require
service, please contact
ILUMINARC® Technical
Support.
Safety Notes
Please read all the following Safety Notes carefully because they include important
information on how to install, use, and maintain this product safely.
Personal Safety
· Avoid direct eye exposure to the light source while the product is on.
· Always disconnect this product from its power source before servicing.
· Always connect this product to a grounded circuit to avoid the risk of electrocution.
· Do not touch this product’s housing when operating because it may be very hot.
Mounting and Installation
· This product is for outdoor use and can be submerged (IP67). However, do not
submerge deeper than 1 m for more than 30 minutes.
· CAUTION: When transferring product from extreme temperature environments, (e.g.
cold truck to warm humid ballroom) condensation may form on the internal electronics
of the product. To avoid causing a failure, allow product to fully acclimate to the
surrounding environment before connecting it to power.
· This product weighs 11.6 lbs (5.26 kg). Always ask for help when mounting this
product to avoid personal injuries or damage to the product.
· Make sure there are no flammable materials close to this product while it is operating.
· When hanging this product, always secure it to a fastening device using a safety cable.
Power and Wiring
· Always make sure that you are connecting this product to the proper voltage, as per the
specifications in this manual or on the product’s sticker.
· Never connect this product to a dimmer pack.
· Make sure that the power input cable is not cracked, crimped, or damaged.
· Never disconnect this product by pulling or tugging on the power input cable.
Operation
· The maximum ambient temperature is 113° F (45° C). Do not operate this product at a
higher temperature.
· In case of a serious operating problem, stop using this product immediately!