ILUMINARC Ilumipod™ 18g2 IP - Manual (Page 15)

Operation
Ilumipod 18g2 IP Optic WW User Manual Rev. 3 11
4. Operation
When you scroll
through the
menu options,
you will see
many of them that do not
correspond with the menu
map. Skip them, as they
do not work with
WW-only output
products.
Ilumicode Addresser
The Ilumipod 18g2 IP Optic WW needs an external controller, the Ilumicode Addresser
(“Ilumicode”), to change its configuration.
Ilumicode Panel Description
Button Function
Enables the currently displayed menu or sets the
currently selected value into the selected
function.
Navigates upwards through the menu list and
increases the numeric value when in a function.
Navigates downwards through the menu list and
decreases the numeric value when in a function.
Turns the unit on. The unit will turn off
automatically after 30 seconds of inactivity.
Control Options
You can set the Ilumipod 18g2 IP Optic WW start address in the 001~512 DMX range. This
allows for the control of up to 512 products in the 1-channel SOLID personality.
Programming
Carry out all the programming procedures indicated below from the control panel. Refer to
the
Menu Map section to learn how the menu options relate to each other.
Use and
DMX Personality
1. Go to PERS and select SOLID.
2. Make sure to rearrange the DMX addresses of all products in the current DMX
universe to avoid address overlapping.
DMX Starting Address
1. Go to DMX.
2. Select a starting DMX address (001~512).