ILUMINARC Ilumipod™ 18g2 IP - Manual (Page 18)

Technical Information
14 Ilumipod 18g2 IP Optic WW User Manual Rev. 3
Troubleshooting Guide
Symptom Cause(s) Action(s)
Circuit breaker/fuse keeps
tripping/blowing
Excessive circuit load Check total load placed on the electrical
circuit
Short circuit along the power wires Check for a short in the electrical wiring
Product does not power up No power Check for power on power outlet
Loose or damaged power cord Check power cord
Faulty internal power supply Return for service to Iluminarc®
Product does not respond to
DMX
Wrong DMX addressing Check Control Panel and product addressing
Damaged DMX cables Check DMX cables
Wrong polarity on the controller Check polarity switch settings on the
controller
Loose DMX cables Check cable connections
Faulty DMX interface Return for service to Iluminarc®
Faulty Display/Main board Return for service to Iluminarc®
DMX signal problems Non-DMX cables Use only DMX-compatible cables
Bouncing signals Install terminator as suggested in the “DMX
Primer” from the ILUMINARC® website at
http://www.iluminarc.com/reports/dmx-
primer
Long cable/low level signal Install an optically coupled DMX splitter
right after the product with the strong signal
Too many products Install an optically coupled DMX splitter
after product #32 or before
Interference from AC wires Keep DMX cables separated from power
cables or fluorescent/black lights