Pl - plasma lift – Future Automation PL User Manual
Page 14

Before mounting any screen, press STOP on the IR remote in
order to prevent any motor movements during the mounting
procedure.
Simply mount the screen on to the mount supplied with your
mechanism. The example below shows a Group A framework.
Mounting the Screen to the Lift
The height of the inner framework is adjustable
in 30mm increments. There is then the final fine
adjustment available from 30mm slots in the
side. The inner uprights will slide to allocate dif-
ferent mounting systems.
When the screen is in position, the cables
can be connected and run down into the
cabinet.
Pass the cables through the hole you cut
in the base for the cables. Once inside the
cabinet, pass the cables in to the cable
management system. This resembles a
black chain running from the beam to the
base of the cabinet that the cables can be
pushed inside to keep them tidy.
In
st
al
la
ti
o
n
:
S
ta
ge
9
Page 13 of 20 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
PL - Plasma Lift