DynaScan Indoor 360 Degree LED Video Display DS0808 - Manual (Page 9)

Source Select
In PBP, PIP, POP, and WPOP mode, you can choose different sources to be the Main and Sub
source. However, only four sources, PC, DVI, Y.Cb.Cr and
Y.Pb.Pr cannot be showed at the
same time. You need to select those four sources to collocate with S-Video1&2, Video1&2
and TV. In other words, VGA, DVI,
Y.Pb.Pr , and Y.Cb.Cr. can’t be displayed side by side.
1. Press Menu to open the setup menu
2. Press Cursor right to select the Display mode
3. Press Cursor down to move the light bar to Main or Sub
4. Press Enter to activate (Light bar becomes brown) and use left and right to change the setting.
5. There are nine sources for you to choose
Source List
VGA
DVI
S-Video1
S-Viideo2
Video1
Video2
Y.Pb.Pr
Y.Cb.Cr
Main
Sub
CATV
Or you can change the selected Screen’s source by press TV, VIDEO, COMP, and PC to switch.
VIDEO=Switch within four video sources, S-Video1&2 and Video 1&2
COMP=Switch between two component sources, Y.Cb.Cr., and Y.Pb.Pr.;
PC= Switch between DVI and VGA
C C
DVI In
PC Audio
In Video
Out
Component
Audio In L/R
Audio Out (L/R)
Audio In Video In S-Video In
Y.Pb.Pr. Y.Cb.Cr/
VGA In
Component
Note. A=2, and B=1. Ex. Video A (Panel)= Video 2 (ISC Menu); Video B (Panel)= Video 1 (ISC Menu)
CATV Channels Scan
Before start use CATV as source, you need use the “CH Scan” to search the existed Channels.
To do “CH Scan”, move to CH Scan of TV SET page and press enter and then press Cursor
Right.
Restore setting:
1. Make sure the ISC is power off with power connected.
2. Press menu button of remote control and then press the power button within two seconds.
3. After reboot the ISC, The Default values as following will be restored.
z
Contrast: 51
z
Brightness: 64
z RGB: R=0, G=0, B=0 (DS0706, DS0716: R:-13, G=0, B=0)
z Volume: 63
z
Display mode: PBP (Picture By Picture, Picture on Picture side by side)
z
Main source: S-Video 1 (source B) (from CF Player)
z Sub source: S-Video 2 (source A) (from CF Player)
Y.Cb.Cr.
Y.Pb.Pr.
1
2