5 receiver settings, 6 receiver status – DekTec DTM-3237 DVB-S2 Receiver User Manual
Page 21

DTM-3237 – OEM DVB-S2 Receiver with DVB-ASI Output
User Manual
21
** This command can only be used in firmware upgrade mode (see category 0x85, setting 0x01).
4.5.5 Receiver settings
Manageable Items – Category 0x90 – Receiver settings
Nr
Variable
Description
Access
Type
0x00 All
All settings in this category
RO
10 bytes
0x01 Receive mode
Receive mode
0* = Transport Stream packets
1 = L.3 baseband frames
R/W
uint8
0x03 Frequency
Frequency in Hertz
Range: 950000000…2150000000
R/W
uint32
0x09 LNB enable
LNB power enabled/disabled
0* = Disabled
1 = Enabled
DE-R/W
uint8
0x0A LNB voltage
LNB voltage
0* = 13V
1 = 14V
2 = 18V
3 = 19V
DE-R/W
uint8
0x0B LNB tone
LNB 22kHz tune enabled/disabled
0* = Disabled
1 = Enabled
DE-R/W
uint8
0x0C DVB-S2 ISI
DVB-S2 input stream identifier
Used to filter a multiple input stream in
case the receive mode is Transport
Stream
Valid range: 0…255
R/W
uint8
0x0D L.3 timestamp
insertion
32-bit timestamp insertion in L.3
baseband frames enabled/disabled
0* = Disabled
1 = Enabled
R/W
uint8
* Factory default
4.5.6 Receiver status
Manageable Items – Category 0x91 – Receiver status
Nr
Variable
Description
Access
Type
0x00 All
All settings in this category
RO
23 bytes
0x01 Locked
Demodulator locked status
0 = No (full) lock
1 = Locked, received data is reliable
RO
uint8
0x02 Frequency
Frequency (Hz)
0 = Unknown or receiver not locked
RO
uint32
0x03 Occupied
bandwidth
Occupied bandwidth (Hz)
0 = Unknown or receiver not locked
RO
uint32