Dataman S6 User Manual

Page 10

Dataman-S6 – MultiControl User's Manual

In Auto Run mode the window will show that programming of the IC is complete. It will also
prompt you to remove the IC.

3-1-6 Run Program

Until a project file (*.lpprj) is loaded into the MultiControl software, this option will be greyed
out.

[Run Program]：Pressing this button will begin programming the IC(s) according to the
project file settings.

[Auto Run]：With this option checked the [Run Program] button will enter into continuous
programming mode.

[Stop All]：Will stop all operations on the connected sites.