d&b Z5409 Horizontal bracket 10S 12S - Manual (Page 5)

The bracket can be:
– directly mounted to walls.
– directly mounted to ceilings or other suitable surfaces.
– horizontally flown and mounted to bars and truss with a tube
diameter of up to 70 mm (2.75") using the Z5010 TV spigot
and the Z5012 Pipe clamp.
Note: Refer to the specific mounting instructions for assembly
and operation of these accessories.
1.4. Mounting options and angle settings
Mounting holes are provided on the tie bar of the bracket.
One centered 9 mm (0.35") hole is provided at each end of the tie
bar for fixing the bracket directly to walls or ceilings or other
suitable surfaces.
Two centered 9 mm (0.35") holes at the d&b standard spacing of
115 mm (4.5") are provided to allow the attachment of the Z5010
TV spigot.
Five mounting holes are provided at each end of the tie bar to
attach the Z5044 MAX Bracket connector, the Z5053 Ci60/Ci90
Bracket connector or the Z5054 Ci60/Ci90 Flying adapter.
One 11 mm (0.43“) hole
[a] and two semi-circular slots [b], [c]
are located at each end of the bracket.
Using the M10 threaded inserts at the top and bottom of the
loudspeaker cabinets, the bracket can be attached in two
directions to allow angle settings over a range of 105° starting
from +15° through to –90°. The following mounting options and
coverage angles are possible.
Option 1
The bracket is attached to the cabinet with hole
[a] facing to the
front of the cabinet. Both bolts are fitted into slot [b].
The vertical coverage angle can be set over a range of 30°
starting from 0° to –30°.
Option 2
The bracket is attached to the cabinet with hole
[a] facing to the
back of the cabinet. One bolt is fitted into hole [a] and the second
one is fitted into the axis of slot [b] and slot [c] to allow the bolt to
move in slot [c].
The vertical coverage angle can be set over a range of 60°
starting from –30° to –90°.
Fig. 3: Z5409/Z5411 Mounting holes
d&b Z5409/11 Horizontal bracket 10S/12S, Mounting instructions (1.2 EN) 5