d&b D6 Hardware - Manual (Page 11)

4. Connections
D6
VOLTAGE SEE LABEL
~ 50/60 Hz, 1000 W
MAINS SUPPLY
DIGITAL AES/EBU ANALOG
OUT
B
OUT
A
CH A
CH B SERVICE REMOTE
4.1. Mains connector
WARNING!
Potential risk of electric shock.
The D6 is a protective class 1 unit. A missing earth (ground)
contact may lead to dangerous voltages in the housing and
controls, and may lead to electric shock.
- Connect the unit to mains voltage supplies with protective
earth only.
- If there is any sign of obvious damage to the power cord
and/or mains connector do not use the power cord and
exchange it before further use of the unit.
- Please ensure the mains connector is accessible at any time
to disconnect the unit in case of malfunction or danger.
- Do not disconnect the PowerCon ®1 mains connector from the
unit while it is connected to the mains voltage supply.
D6
VOLTAGE SEE LABEL
~ 50/60 Hz, 1000 W MAINS SUPPLY DIGITAL AES/EBU ANALOG
OUT B OUT A
CH A
CH B SERVICE REMOTE
D6
ÉZ2700.000WË
D6
100-127V / 220-240V
Z270000000001 WEEE
0615
A PowerCon mains connector [8] is fitted on the rear panel and an
appropriate mains lead is supplied.
Before connecting the device to mains voltage, check that the mains
voltage and frequency correspond to the specifications on the
configuration sticker on the rear of the D6.
1 PowerCon ® is a registered trademark of the Neutrik AG, Liechtenstein
D6 Amplifier, Hardware manual (1.9 EN) Page 11 of 24