CUE rfCUE - Manual (Page 8)

User Manual rfCUE
www.cuesystem.com
Page 8 of 18
5. Button Labels
The labeling is provided by a plastic foil inserted under the buttons.
Foil preparation steps
1. Use AutoCAD file named CS0170.0007.1-Foil.dwg for preparation of a layout. This file is
available on www.cuesystem.com. The foil shape is described on the picture below.
2. Print the foil on a standard printer.
3. Cut the foil into a shape according the picture (see above).
4. Put the panel upside down.
5. Unscrew the two screws from the rear side of the panel.
6. Remove the front panel with buttons and foil still holding it upside down.
7. Replace
foil.
8. Put the front panel back.
9. Fasten the screws.