CUE rfCUE - Manual (Page 10)

User Manual rfCUE
www.cuesystem.com
Page 10 of 18
7. Modify Mode
7.1. Overview....................................................................
Before starting, please check first if you have all the following items
1. File RFMOD.EXE to involve modification of the address of rfCUE 99
2. rfbaseCUE with power source
3. Windows PC with one free serial port
4. Communication cable between rfbaseCUE HOST connector and PC.
The program RFMOD.EXE makes the rfbaseCUE send via RF a special command, which will set the
receiving rfCUE to modify mode. To send this command can be also achieved directly from the
rfbaseCUE service mode – see User Manual rfbaseCUE. The rfCUE is able to receive this command
only when back-light button is pressed.
7.2. How to Display the Address .......................................
Steps are
1. Disconnect RS-485 signals A and B on the rear panel of the rfbaseCUE, connect the power.
2. Connect your PC to the rfbaseCUE HOST connector using a data communication cable.
3. Press the back-light button on the rfCUE and hold it.
4. Run
the RFMOD.EXE (in DOS window) still holding the back-light button. The operation now
lasts for several seconds.
5. The LED under the back-light button starts to blink several times.
6. On the LEDs under the first 8 buttons there will be a binary value of current address of the
rfCUE 99 displayed. The leftmost upper LED means LSB bit. Red color means log. 1. When
current address is 0 then the first 8 LEDs remain green, when current address is 1 then the
leftmost upper LED goes red and the rest remain green, …
Address 0 Address 1 Address 2 Address 3 Address 4
Address 5 Address 6 Address 7 Address 8 Address 9
Green = 0 Red = 1
7. The rfCUE 99 returns to normal operation after releasing the back-light button.