Desa (V)K36N SERIES - Manual (Page 23)

111923-01B
For more information, visit www.desatech.com For more information, visit www.desatech.com
23
23
FIREPLACE INSTALLATION
Continued
FIREPLACE INSTALLATION
Installing Logs, Lava Rock and Glowing Embers
OPERATING FIREPLACE
For Your Safety Read Before Lighting
Figure 47 - Installing Log No. 7
INSTALLING LOGS, LAVA ROCK AND
GLOWING EMBERS
Each log is marked with a number. These numbers will help you
identify the log when installing. It is very important to install these
logs exactly as instructed. Do not modify logs. Only use logs
supplied with fireplace.
Open louvers, remove screen, unlock door latches, and open glass
door. See Removing/Replacing Glass Door, steps 1 and 2 on page 22.
Install logs according to instructions for fireplace model numbers.
1. Place log #1 (left base log) onto pin on left side of burner as
shown in Figure 44.
2. Place log #2 (right base log) onto pin on right side of burner as
shown in Figure 44.
3. Place logs #3 (left front log) and log #4 (right front log) onto
pins as shown in Figure 45.
4. Place log #5 (right rear log) onto pins on right rear of burner
(see Figure 46). Rest log #6 (middle crossover log) on top of
log number 2 as shown in Figure 46.
5. Place back end of log #7 (left rear log) onto pin on left rear
burner and rest front onto log #1 as shown in Figure 47.
6. Rest log #8 (left crossover log) onto log #3 and rest log #9 (right
crossover log) onto logs #4 and #5 as shown in Figure 48.
7. Pull ember material apart into pieces no larger than a dime. Place
these pieces loosely and sparingly directly onto the exposed front
section of the burner (see Figure 49). This will create the glowing
ember appearance as the flame touches the ember material. Do
not block air slots by using too much ember material in one area.
It is not necessary to use all of the ember material provided.
Figure 44 - Installing Logs
No. 1 and No. 2 Figure 45 - Installing Logs
No. 3 and No. 4
Figure 46 - Installing Logs
No. 5 and No. 6
1
2 3
4
5
6
7
8
9
Figure 48 - Installing Logs No. 8 and No. 9
Ember Material
Figure 49 - Placing Ember Material on Burner
WARNING: The glass door must be securely in
place before running this fireplace. Do not run this
fireplace if glass is missing or broken.
NOTICE: Do not put lava rock on burner or under
burner. Placing lava rock on burner will cause perfor-
mance problems.
8. Close glass door, lock door latches, replace screen, and close
louvers (see Removing/Replacing Glass Door, steps 5 through
7 on page 22).
OPERATING FIREPLACE
WARNING: If you do not follow these instructions
exactly, a fire or explosion may result causing prop-
erty damage, personal injury or loss of life.
A. This appliance has a pilot which must be lighted by hand.
When lighting the pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area
for gas. Be sure to smell next to the floor because some gas
is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone
in your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
FOR YOUR SAFETY READ
BEFORE LIGHTING