Dish Network EZ - Manual (Page 20)

118866 19
Table 2: How I Change My VCR Channels
Column 1:
How do you change your VCR
to Channel 3 using the number
buttons? Column 2:
Circle the number
sequence you use to
change your VCR to
Channel 3
“I just press the number buttons
on my remote to change the
channel.”
If you only press 3 on your
remote control to change the
VCR to Channel 3, circle the “3”
to the right in Column 2 and go to
step 16.
“I have to enter a zero before the
channel numbers.”
If you press 0, 3 on your remote
control to change the VCR to
Channel 3, circle the “0, 3” to the
right in Column 2 and go to
step 16.
“I have to press Enter after I
press the off-air channel
numbers.”
If you press 0, 3, Enter on your
remote control to change the
VCR to Channel 3, circle the “0,
3, SELECT” to the right in
Column 2 and go to step 16.
“I enter a special number
sequence not found above.”
In the space to the right, enter
your special number sequence
you use to change your VCR to
Channel 3 (max. four entries).
Then circle this sequence you
wrote and go to step 16.
3
0, 3
0 , 3 , Select