Computronic Controls Sentinel 150P - Manual (Page 18)

SNTL150P-PCSUITE installation & operation ci0052 p18/28 issue 2 2014-01-09
SNTL150P Configurable Settings
Charger Profiles
Depending upon access password entered, the selection or creation of new charger profiles is available. The
configurable fields are as follows:
PROFILE NAME Name of profile*
*Note: This is for local PC storage of profile, not stored
or saved by SNTL150P.
FLOAT VOLTAGE This should be according to manufacturer
recommendations for battery type, i.e Wet Lead Acid =
2.25V/p/c = 12V Settings = 13.5Vdc
BOOST VOLTAGE This should be according to manufacturer
recommendations for battery type, i.e Wet Lead Acid =
2.23V/p/c = 12V Settings = 14.1dc
BOOST INITIATE VOLTAGE The voltage at which the SNTL150P Initiates Boost
Function. This should be a voltage lower than Float
voltage, typically nominal (i.e. 12V or 24V)
BOOST PERIOD Amount of Time for Charger to remain at Boost Voltage
before returning to Float
LOW ALARM VOLTAGE Low Alarm Voltage Setting
HIGH ALARM VOLTAGE High Alarm Voltage Setting
NUMBER OF CELLS Used for correct calibration of Temperature
Compensation. If, such as in the case of Power Supply
modes, no temperature compensation is required enter
‘0’
Preset Charger Profiles
The SNTL150P contains an inbuilt list of the most common type of batteries used, these can be selected from the
drop down menu:
12V Wet Lead Acid
12V Calcium Calcium
12V Lead Acid Antinomy
12V VRLA
– AGM
12V VRLA – Gel
10 Cell NiCd
18 Cell NiCd
20 Cell NiCd
24V Wet Lead Acid
24V Calcium Calcium
24V Lead Acid Antinomy
24V VRLA
– AGM
24V VRLA – Gel